61032924
MOUNTING SET FOR BMW & LR/RR DRIVE SHAFTS MANUAL
Reassembling drive shafts can be difficult, especially when pushing the shaft through the bearing into the drive flange without damaging the CV boot or surrounding components. This set allows controlled installation by drawing the drive shaft into the hub flange using an M22 threaded spindle and nut.
Adaptors are made from high-strength steel and are suitable for drive shafts with M24x1.5 and M27x1.5 threads. Commonly used on BMW and Land Rover / Range Rover vehicles.
Adaptor for M24x1.5
Adaptor for M27x1.5
Carriage beam M22, 250 mm
Press pipe Ø44.7 mm
Thrust washer
Flange nut M22
Note: Optional adaptor for later Land Rover / Range Rover vehicles with M24x2 thread available separately – part no. 61080521.
Adaptor for M24x1.5
Adaptor for M27x1.5
Carriage beam M22, 250 mm
Press pipe Ø44.7 mm
Thrust washer
Flange nut M22
Note: Demonstration video shows use with optional 8.5-ton hydraulic cylinder, not included in the set.
002
Adaptors are made from high-strength steel and are suitable for drive shafts with M24x1.5 and M27x1.5 threads. Commonly used on BMW and Land Rover / Range Rover vehicles.
Adaptor for M24x1.5
Adaptor for M27x1.5
Carriage beam M22, 250 mm
Press pipe Ø44.7 mm
Thrust washer
Flange nut M22
Note: Optional adaptor for later Land Rover / Range Rover vehicles with M24x2 thread available separately – part no. 61080521.
Adaptor for M24x1.5
Adaptor for M27x1.5
Carriage beam M22, 250 mm
Press pipe Ø44.7 mm
Thrust washer
Flange nut M22
Note: Demonstration video shows use with optional 8.5-ton hydraulic cylinder, not included in the set.
002