Generation 2 Wheel Bearing Removal/Installation Set

Our wheel bearing sets are designed to be used on the vehicle and are replaced with minimal strip down of components, this saves time, damage and awkward setting up on a workshop press.

An 18 or 22 ton hydraulic cylinder is used in conjunction with the wheel bearing set required (generation 1,2 & 3 sets, available separately) and the bearing is replaced on the vehicle. In most cases, suspension, steering and ABS components can be left connected preventing the need for wheel alignment etc.

Vehicles fitted with Generation 2 wheel bearings:
Peugeot Expert
Citroen Dispatch
Vauxhall Vivaro
Toyota Proace
VW Lupo, Polo,Transporter T5, Touareg
SEAT Cordoba
VOLVO V50/S40, V70/ S80 und XC60
FORD Focus, C max, Mondeo, S-Max and Kuga
MAZDA 3, 5, 6, and CX-7
LANDROVER Freelander 2
MERCEDES BENZ Vito and Sprinter
SMART Forfour

We offer a wide range of accessories which can be added at anytime, these include:

- Generation 1 wheel bearing set
- Generation 2 wheel bearing set
- Generation 3 wheel bearing set
- Land Rover Range Rover wheel bearing set for later aluminium hubs
- Commercial vehicle wheel bearing sets
- 4 & 5 stud drive shaft removal hubs
- Hydraulic ball joint splitter 4.5 ton universal
- Hydraulic ball joint splitter 8.8 ton for Land Rover Range Rover